|
True Spin is so easy and fast, you can mark
your ball almost anywhere, any time.
The first time you use True Spin
Your True Spin may be shipped with the batteries installed. If so, open the battery compartment and remove the plastic strip before using your True Spin for the first time. If your batteries were shipped uninstalled, insert them according to the diagram in the battery compartment.
Spin the ball
1. Set True Spin on a stable surface and remove the clear cover.
2. Place the ball on the gyroscopic cradle and replace the cover.
3. Press the activator button. You do not need to hold the button; just press once to begin the spinning process.
4. Allow the ball to spin for about 20 seconds until it reaches its point of equilibrium.
Mark the ball the way you want
Some golfers like to mark the balance line all the way around the equator of
the ball. Others prefer to only mark the very top of the ball (the axis)
with a small dot. Either way works.
1. To mark your ball with a line around its equator, gently insert the tip of the marking pen through the access on the side of the cover.
2. To mark the top of your ball with a small dot, insert the tip of the pen through the access hole on the top of the cover.
3. Remove the pen and press the activator button again. Let the ball come to a complete stop.
8. Remove the cover and you’re ready to hit the sweet spot every time.
Position the ball
When hitting or putting, position your ball with the equator line vertical and aimed at your target (as you look down on the ball). If you’ve marked your ball with only a dot, position the ball with the dot
between your legs at address. This places the sweet spot in line with your
club head.
|
